Looking for Gold at the Barrier Level

The settling of the earth that happens, means that there is most likely not a lot of gold right on the top. If the top dirt is sand or gravel, the gold is likely to settle through it as time goes by until it comes to an unyielding layer. This layer might consist of bedrock, which is the central rock layer that is deep inside of the earth. It is also possible that the layer may consist of old lava flow, hard clay or any other thing that could avoid the downward settling of the gold. If you manage to find traces of gold close to the surface, you should keep on digging at it while panning it as you work down. The amount of color you come across should get better as you get closer to the obstruction.

Something else gold prospectors may be interested in knowing is that gold can many times be found mixed in with red or black sand. The red sand is what is known as ruby sand and it is made up of tiny crushed up garnets. The black sand is a type of iron oxide and it is heavy sand as well as magnetic making it very easy to find.

Now, even though gold can often times be found in these two types of sand, it is still necessary to observe the way the red or black sand is spread out. if it is distributed out evenly, the amount of gold you will be able to obtain will not be a great amount. However if the black or red sand can be seen in very defined layers, it is likely the gold will be more highly concentrated in these specific areas.

There is another thing that is also very easy to go along with, and so much so that it very often times confuses people. When it is evident that the area you have found has already been mined on. When this type of area is found, it means that it is an area that has already been mined on. However, this does not mean that there is not going to be any gold there anymore, there is a good chance that there may still be gold in that mountain. However, it is highly suggested to not go to the specific places where someone has already worked on unless you are willing to put up with all of the hours you are going to spend working out.

The last person that worked on this area was probably just as determined as you are to dig out some gold and may have been a bit more experienced then you at the task. Most likely the previous miner continued digging until he decided there was no use in keeping on in that specific area. Therefore, if the person before you stopped at that spot, it should be enough of an indication for you to avoid bending your back in that area. When searching out for a spot, look over the whole situation and area and try to picture the geology and use the clues you know. You can then move over to an area that does not have a shaft; this may only be sixty feet away.

One thing you should be very careful about and avoid is to prowl around inside of old mine shafts, because they could end up being very dangerous for your health. Some of the dangers of going inside an old mine shaft are falling down vertical mine shafts – keep in mind that these can be very deep – another hazard is spiders, rattlesnakes, as well as rocks that could fall. Remember that years ago people used to use dynamite to blast open the tunnels and there could also be dynamite sticks left laying inside and the problem with that is that once dynamite has been sitting for a long time the nitroglycerine in it can concentrate in one specific area and it could go off even if someone handles it very gently.